Knowledgebase
Jakinid Support Website > Help Desk (Jakinid.com) > Knowledgebase

Search help:


How can I make ACTAtek device become Wireless connection?

Solution

We do offer a wireless adapter or 3G modem(also support WiFi adapter) which you can find more information at:


http://jakinid.com/iot-devices-products/wifi-adapter/

&

http://jakinid.com/iot-devices-products/3g-gsm-wifi-gateway-modem/



Precautions:
WIFI signal varies with hardware and environment.

Setting this up:
First you will need to configure the WIFI adapter to be in client mode ,and enter in the SSID and WIFI password by connecting it via USB to your computer. Save these settings and then try connecting the WIFI adapter's Ethernet to your own laptop's Ethernet port. If the WIFI Adapter successful connects on to the WIFI router on site, your laptop will have Internet connection.

Afterwords, you can disconnect the Ethernet cable to the Laptop and connect it to the ACTAtek3 device.

Keep in mind the farther away from the the WIFI router, a lower link quality will be observed.
If you are out of range of the WIFI network, the WIFI adapter will not be able to connect to the WIFI Router.

I hope this clarifies the set up procedure to make ACTAtek3 become Wireless connection.

Note:The attached file was an example for the above setup.

Attachments:
wifi_adapter.pdf wifi_adapter.pdf

Article details
Article ID: 40
Category: General

 
« Go back

 
Powered by Help Desk Software HESK - brought to you by Help Desk Software SysAid